Thru - way project
Page 2
I took an old pine table top I salvaged many,many years ago .I
cut it down to 13" and ran it through the planer to straighten and
clean up the surface. I glued and pocket drilled the backside to
make a super strong joint.
The Top Side
The top has been finished sanded and ready for about 5
coats of polyurethane.
A test fit before the cosmetic work begins
Go to Home Page
Comments, Questions or Problems
with the links Click here
The project is almost done. These are the semi-final pictures. The
only thing left is the gar at the rear of the opening, caulk around the
bar to wall surface & very little paint touch up.
How to Make a Thru-way or Wall Bar